General grid interface
Hi, I have a structured mesh an a unstructured mesh, between this meshes I have a GGI Connection. I'd like to know if there is a rapport between the nodes of the meshes that must be applay.
Tanks and have a nice day. Daniele |
Re: General grid interface
Daniele,
I'm not sure what you mean by "a rapport between the nodes", but if you are asking if you need to consider the topology on either side, the answer is no. The only consideration is that the geometric surfaces must be the same (within ~10% of element size). If you are dealing with a frame or pitch change, only the hub and shroud curves need to line up, the periodic surfaces don't. Regards, Robin |
Re: General grid interface
Hi Robin, thanks for your answer, was helpfull.
Regards, Daniele |
Hi, Robin
i can't understand "hub and shroud curves need to line up", could you explain it? thanks |
I'm pretty sure people who submitted as Guests in 2003 are not going to respond...
|
Quote:
Frame or pitch change may occur but the modeller's guide explains everything about the domain interfaces. |
thank you for your reply, i get it.
|
All times are GMT -4. The time now is 16:20. |