 |
 |
 |
|
|
|
[Sponsors] | ||||
September 6, 2003, 12:15
|
result about tturbulent modelling
|
#1 |
|
Guest
Posts: n/a
|
i use hot jet flow in space(control volume) i want know if i use turbulent model (Zero Equ,K-eps ,K-omega, RNS,) how the result different ?
thank ! |
|
|
||
|
September 8, 2003, 03:46
|
Re: result about tturbulent modelling
|
#2 |
|
Guest
Posts: n/a
|
Hi, Jack
Try to figure out what is the Rayleigh or Froude number of your case. For example, if the Rayleigh number is over 1.0E10, it's supposed to be turbulent, then eddy viscosity two equations models could be ok for your jet flow. Regards Forrest |
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Comparison the airfoil 0012 experimental result and simulation result | harrislcy | FLUENT | 30 | August 29, 2013 10:27 |
| Read Result Files or User Defined Result | Aquilaris | ANSYS | 0 | February 9, 2011 05:25 |
| Advice on multi-phase flow modelling | Martin | Main CFD Forum | 3 | October 14, 2008 05:16 |
| how to ensure that your modelling is correct | rvndr | Main CFD Forum | 7 | March 1, 2004 12:21 |
| Computational Modelling of Vortex Separators | May Lim | Main CFD Forum | 6 | November 13, 1998 12:36 |
Linear Mode
