 |
 |
 |
|
|
|
[Sponsors] | ||||
September 9, 2003, 08:28
|
Build stops!
|
#1 |
|
Guest
Posts: n/a
|
What do you think about CFX skipping Build and replacing it with a mixture of Icem Tetra and Ansys DesignModeler in 2004? (See CFX community pages for info) -Michael Bo
|
|
|
||
|
September 9, 2003, 12:33
|
Re: Build stops!
|
#2 |
|
Guest
Posts: n/a
|
I would be dissappointed. But, perhaps they will provide it for free without support. I see some market openings here..............
Astrid |
|
|
|
||
|
September 12, 2003, 23:09
|
Re: Build stops!
|
#3 |
|
Guest
Posts: n/a
|
Not likely.... It seems that since ANSYS owns ICEM and Build was based on MSC's Patran, that Build no longer fits the ANSYS business plan.
|
|
|
|
||
|
September 16, 2003, 22:02
|
Re: Build stops!
|
#4 |
|
Guest
Posts: n/a
|
I also just found out that the CFX offices are using the new ANSYS/ICEM/CFX hybrid pre-processor in their latest training courses. I suspect it should ship soon.
Jeff |
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| OpenFoam 1.6-ext - RPM build errors | preibie | OpenFOAM | 12 | September 8, 2011 03:12 |
| 64bitrhel5 OF installation instructions | mirko | OpenFOAM Installation | 2 | August 12, 2008 18:07 |
| OpenFOAM build from source instructions | tj22 | OpenFOAM Installation | 7 | April 6, 2006 16:15 |
| switching from build 2 ICEM CFD 4.CFX | bogesz | CFX | 4 | February 27, 2004 01:31 |
| CFX Build 5 question... | cfd guy | CFX | 6 | June 19, 2001 22:38 |
Linear Mode
