|
[Sponsors] |
September 8, 2003, 19:25 |
Creating SOLID-REP
|
#1 |
Guest
Posts: n/a
|
Hi, I´m having a problem to create the solid b-rep in the CFX 5.5. I am modelling a turbulence flow in a body.
It have 80 surfaces and I already made the "EDIT /SURFACE/EDGE MATCH" and too "VERIFY/SOLID/B-REP" and both are correct. When I request the "CREATE/SOLID/B-REP", the program begun to run and after a few moment,(maybe one minute) it just close without any information. Would somebody help me? How can I obtain more information about the problem? Would it be because of the hardware? I hope somebody answer's. Regards at all. Lucio |
|
September 9, 2003, 08:30 |
Re: Creating SOLID-REP
|
#2 |
Guest
Posts: n/a
|
HI, It shouldn't be the hardware. Does build repeatedly close when you try to create the brep again ? When viewing your surfaces, what do the display lines in build look like. You should see two vertical and two horizontal lines on each surface. Do these lines look evenly spaced (apart from on trimmed surfaces !). These lines will indicate if you have any pooly parameterised surfaces. If you do have such surfaces you may need to rebuild them. Bob
|
|
September 9, 2003, 13:08 |
Re: Creating SOLID-REP
|
#3 |
Guest
Posts: n/a
|
Thanks Bob Well, yes, the Build close repeatdly.. In fact I can see lines spaced from the trimmed surface. But I thought that all connection would be corrected when I did the EDGE MATCH function. Thanks for your reply. I´ll try to rebuild the the body. Lucio
|
|
September 10, 2003, 19:22 |
Re: Creating SOLID-REP
|
#4 |
Guest
Posts: n/a
|
The modification gave results. I create the solid B-REP Thanks again, Bob. Lucio.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
solid to fluid heattransfer with chtMultiRegionFoam | nakor | OpenFOAM | 11 | March 21, 2011 08:28 |
[GAMBIT] problems creating moving solid | free | ANSYS Meshing & Geometry | 5 | October 7, 2010 01:54 |
creating solid from car body surface data | Mehmet Yilmaz | FLUENT | 1 | January 16, 2008 06:57 |
creating a solid body in Design Modeller | Dan | CFX | 0 | May 24, 2004 11:59 |
CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |