 |
 |
 |
|
|
|
[Sponsors] | ||||
January 17, 2004, 11:40
|
stream line
|
#1 |
|
Guest
Posts: n/a
|
Dear All, I am in of your help, I have water flow through a nozzle. when I greated the stream line at inlet in CFx5.6 post. However, the prgram did not draw any thing as line or deoplets. I do not know why
I tried to change the flow direction but the program did not too |
|
|
||
|
January 18, 2004, 19:24
|
Re: stream line
|
#2 |
|
Guest
Posts: n/a
|
The point that you specified for the streamline to pass, might be out of the domain.
KSA |
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Gmsh] Problem with Gmsh | nishant_hull | OpenFOAM Meshing & Mesh Conversion | 23 | August 5, 2015 02:09 |
| OpenFOAM 1.7.1 installation problem on OpenSUSE 11.3 | flakid | OpenFOAM Installation | 16 | December 28, 2010 08:48 |
| Regarding FoamX running Kindly help out | hariya03 | OpenFOAM Pre-Processing | 0 | April 18, 2008 04:26 |
| [blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |
| error while compiling the USER Sub routine | CFD user | CFX | 3 | November 25, 2002 15:16 |
Linear Mode
