|January 23, 2004, 13:15||
Frozen Rotor Interface Problems
My problem is that a frozen rotor interface doesn`t work in CFX5.6solver since the theta extent is too small. The out file gives three possible reasons for the failure. I went through my topology quite some time and there is none of the latter two (zero radius, surface normal and parallel). I don`t know exactly what is meant by `surface more than 360 degree of revolution` but the geometry only has 120°. I guess I can exclude this cause.
Does anyone have experience with a related problem or knows another reason for the interface to fail? What exactly is a too small theta extent?
Thanks a lot for the answers!
|Thread||Thread Starter||Forum||Replies||Last Post|
|Frozen Rotor Model CFX||windsim||CFX||13||January 5, 2012 14:25|
|[ICEM] Problems with coedge curves and surfaces||tommymoose||ANSYS Meshing & Geometry||0||August 5, 2011 16:02|
|Needed Benchmark Problems for FSI||Mechstud||Main CFD Forum||4||July 26, 2011 12:13|
|Frozen Rotor and Wake of a Wind Turbine||Peter||CFX||0||June 26, 2006 15:12|
|Some problems with Star CD||Micha||CD-adapco||0||August 6, 2003 13:55|