 |
 |
 |
|
|
|
[Sponsors] | ||||
February 13, 2004, 20:03
|
Inlet duct projection
|
#1 |
|
Guest
Posts: n/a
|
Hi
I am working with cyclone separator (CFX 5.6). I have created inlet duct. I have created curve from intersection between the surface duct and the surface cyclinder of the cyclone. Further, I have trimmed the curves from the cylindert surface. In case of creating solid by method of B-rep, I have the following message: "A gab exist between two faces of the body" I have tried to use edit/surface/edge match to close the gab but I have the same problem. Can any one help me in this problem. Moreover, can anyone inform me how to create the inlet duct with the cyclone and the projection and trimmed surface. Best regards |
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to specify an inlet boundary conditions for a fully developed gas flow in a duct. | legendyxg | FLUENT | 2 | May 11, 2010 07:32 |
| Inlet shapes for modelling a fan in an inlet duct | buzzybee | CFX | 10 | June 11, 2009 20:15 |
| Defining Duct Inlet Pressure Distribution? | Eric | FLUENT | 1 | February 8, 2008 16:50 |
| Periodic BC on Inlet and Outlet of a Duct | Steve | CFX | 2 | August 8, 2005 12:03 |
| flow simulation across a small fan | jane luo | Main CFD Forum | 15 | April 12, 2004 17:49 |
Linear Mode
