 |
 |
 |
|
|
|
[Sponsors] | ||||
February 21, 2004, 06:09
|
CFX 5 & TASCFLOW comparison
|
#1 |
|
Guest
Posts: n/a
|
All,
We are simulating a secondary flow (gas turbine leakage flow) using CFX5.6 and TASCflow. For the same BC, and same CFD model, we see a significant difference between CFX5 and TASCflow results (pressure drop). Does anybody has clue / suggestions for this issue. We have seen good comparison for statoric components. But for rotating components, this difference is seen at UD as well as higher order schemes. Thanks in advance |
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Pros and Cons for CFX, CFdesign, COMSOL | Val | Main CFD Forum | 3 | June 10, 2011 02:20 |
| comparison with analytical results (1D)and(3D) CFX | Rogerio Fernandes Brito | CFX | 2 | October 28, 2008 20:26 |
| Importing solutions in CFX. | Alphonso | CFX | 1 | August 1, 2008 14:01 |
| comparison Of CFX with FLUENT | rou | CFX | 3 | April 26, 2003 01:10 |
| CFX 4.4 installation problem | Pandu Sattvika | CFX | 1 | December 1, 2001 04:07 |
Linear Mode
