TASCflow simulation result problem? -- CFD Online Discussion Forums

February 22, 2004, 07:54	TASCflow simulation result problem?	#1
Mason Guest Posts: n/a	Hello all, I'm simulating the centrifugal pump with one guide blade between two blades. The calculating result was not reasonable. The streak line was pass through the guide blade. One of my setting in the B.C. is WALL-->rotational. Which is include two blade, one guide blade, and the impeller surface. But my blade and guide blade is no thickness. Were you have any experience like that? Could you discuss with me? Thaks a lot. By Mason.

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
about valve closing problem during ANSYS FSI simulation	ivy	CFX	4	June 8, 2011 21:01
Problem restarting a simulation from an intermediate point.	sergiorbrett	CFX	2	April 21, 2010 17:11
Mass conservation problem in mixing tank multiphase simulation	rockewan	FLUENT	0	April 6, 2010 12:34
Problem about 3D blunt body high Re simulation	David	FLUENT	0	September 27, 2002 10:59
Install problem of X-windows for Tascflow	Alex Deng	CFX	2	November 1, 2001 11:33

All times are GMT -4. The time now is 15:52.