CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   CFX (http://www.cfd-online.com/Forums/cfx/)
-   -   a question in ICEM (http://www.cfd-online.com/Forums/cfx/20336-question-icem.html)

feng May 5, 2004 11:51

a question in ICEM
 
I want to simulate a centrifugal pump,whose inlet is a cylinder pipe.I only need to simulate one channel,so the inlet should be a 60-degree-sector region (I have six blades),I do not know how to make grids in this region,because it only has three edges at one section,who can tell me?

thank you

centaur_ks May 5, 2004 18:18

Re: a question in ICEM
 
use O-grid to make the grid in pipe region so that it will not create the wedges at the center.


All times are GMT -4. The time now is 06:37.