|
[Sponsors] |
May 7, 2004, 12:19 |
CFX-VNC:exportDISPLAY
|
#1 |
Guest
Posts: n/a
|
Hi test
I log on to telnet. But it didn't work. this is what I did: :log on:myUSEERID wd: I entered output %(machinename):exportDISPLAY=ISP:0.0 the error message:Command not found Please lemmie if I did the right thing. Regards |
|
May 10, 2004, 03:38 |
Re: CFX-VNC:exportDISPLAY
|
#2 |
Guest
Posts: n/a
|
you are typing the command wrong..
it is export (space) Display=10.112.1.3:0.0 Where the IP address is that of your windows machine. If you dodnot know the IP address of windows machine, go to command prompt and type "ipconfig" Hey this will only work if u have exceed installed on ur windows machine, else u will get the same error |
|
May 17, 2004, 09:11 |
Re: CFX-VNC:exportDISPLAY
|
#3 |
Guest
Posts: n/a
|
hey test thanks alot. But unfortunately I don't 've exceed installed on my windows PC. I try if I can get one. Thanks alot.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Proper way to name boundaries on 2D model for use in CFX? | RossFS | ANSYS Meshing & Geometry | 4 | November 10, 2011 02:38 |
Pros and Cons for CFX, CFdesign, COMSOL | Val | Main CFD Forum | 3 | June 10, 2011 02:20 |
CFX pressure in Simulations problem | nasdak | CFX | 1 | April 14, 2010 13:22 |
PhD using CFX | Rui | CFX | 9 | May 28, 2007 05:59 |
CFX 4.4 installation problem | Pandu Sattvika | CFX | 1 | December 1, 2001 04:07 |