CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   CFX (http://www.cfd-online.com/Forums/cfx/)
-   -   how to see the mesh in PRE/POST? (http://www.cfd-online.com/Forums/cfx/20431-how-see-mesh-pre-post.html)

ioana June 10, 2004 13:56

how to see the mesh in PRE/POST?
 
Hi everybody!

I want to know if there is a way to see the mesh in POST or PRE. It's very urgent!

Have a nice day, Ioana

Francisco A Duque June 10, 2004 20:28

Re: how to see the mesh in PRE/POST?
 
Hi Ioana,

Just load the gtm file in post, and then edit the wireframe object setting Edge angle to 0 degrees. that should display your surface mesh in the 3D viewer.

I hope that is the answer you were looking for.

Regards

Paco

matej June 11, 2004 02:10

Re: how to see the mesh in PRE/POST?
 
Or if you want to see the mesh (to see the density at particular places or whatever) you define a plain and on render tab for this plane click the "draw lines" on.

in cfx5.7 is the surface mesh displayed from the moment you define the domain. At least it does for me :o)).I think.

matej

ioana June 11, 2004 04:27

thank you
 
Hi Paco & Matej!

Thanks a lot for your advice. It works!

Have a nice day, Ioana


All times are GMT -4. The time now is 03:28.