 |
 |
 |
|
|
|
[Sponsors] | ||||
July 5, 2004, 20:29
|
help about the simulation of cyclone
|
#1 |
|
Guest
Posts: n/a
|
I am simulating for the cyclone using CFX5. The Reference is the 3.1MPa. I met some questions: For the swirling flow, I used the transient approach and RSM SSG model. During the calculation, the pressure drop keep increasing and more higher than that got from the emperical formula. I set the timesteps as the time flow pass 5 degree in cyclone. I should set the oulet as average static pressure or static pressure? I found that, if I set it as static pressure, the pressure drop keep decreasing. If I set it as average static pressure, the pressure drop keep increasing. Who can give me a answer?
Best wish Xinfeng LI(lixinf@163.com) LI Xinfeng |
|
|
||
|
July 7, 2004, 02:55
|
Re: help about the simulation of cyclone
|
#2 |
|
Guest
Posts: n/a
|
Who can help me?
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Suggestions for modelling a cyclone | adona058 | OpenFOAM Running, Solving & CFD | 2 | June 17, 2011 14:43 |
| Cyclone Simulation (simpleFoam) | erncyc | OpenFOAM | 4 | January 28, 2011 09:40 |
| velocity profile export from a simulation onto another | sudhirlv | STAR-CCM+ | 1 | September 12, 2010 18:57 |
| Replacing mesh while running a simulation | akultane | CFX | 1 | November 15, 2009 13:46 |
| About multiphase simulation for cyclone separator | Sushil | Main CFD Forum | 0 | July 7, 2007 05:45 |
Linear Mode
