Home > Forums > Software User Forums > ANSYS > CFX

CFX 5.7 mesh refinement troubles

Updated Threads

Reply

Search this Thread

July 8, 2004, 14:40	CFX 5.7 mesh refinement troubles	#1
imike Guest Posts: n/a	How much memory should be in the system to make mesh adaptation? I have insufficient memory message when doing 2nd refinement step in any small projects... RAM 512, swap ~3GB

July 8, 2004, 18:16	Re: CFX 5.7 mesh refinement troubles	#2
Glenn Horrocks Guest Posts: n/a	Hi Imike, There has been a service pack of CFX released which addresses this problem. I suggest you download and install it and try the simulation again. Regards, Glenn

Reply

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] SnappyHexMesh for internal Flow	vishwa	OpenFOAM Meshing & Mesh Conversion	24	June 27, 2016 08:54
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere!	sc298	OpenFOAM Meshing & Mesh Conversion	2	March 27, 2011 21:11
cfx mesh problem...	mactech001	ANSYS Meshing & Geometry	0	November 5, 2009 02:19
basic of mesh refinement	arya	CFX	4	June 19, 2007 12:21
Icemcfd 11: Loss of mesh from surface mesh option?	Joe	CFX	2	March 26, 2007 18:10

All times are GMT -4. The time now is 21:59.