 |
 |
 |
|
|
|
[Sponsors] | ||||
August 6, 2004, 07:04
|
Pressure outside of upper limit
|
#1 |
|
Guest
Posts: n/a
|
How can I increase the table range for pressure ? I get the following message. The reported maximum value [Pa] is about the value of inlet total pressure into my domain.
"While evaluating Static Entropy, Static Pressure on domain gaspath went outside of its upper limit. Its maximum value was 1.3652E+06. The bounds error was handled by clipping. If this situation persists, consider increasing the table range." Thanks for your ideas. M. |
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fluent natural ventilation pressure boundary condition | pierresandre | FLUENT | 24 | November 8, 2011 14:32 |
| Solution variables goes outside upper limit -how to localize fatal overflow occurance | Dimone | CFX | 2 | January 21, 2011 06:35 |
| Does the variable 'nbl' have an upper limit? | therockyy | FLOW-3D | 5 | September 10, 2010 21:58 |
| UDF to define or adjust pressure??? | engahmed | FLUENT | 0 | July 6, 2010 17:19 |
| Temperature went outside of its upper limit | Atit Koonsrisuk | CFX | 0 | January 8, 2004 11:43 |
Linear Mode
