 |
 |
 |
|
|
|
[Sponsors] | ||||
August 8, 2004, 22:40
|
ICEM mesh export
|
#1 |
|
Guest
Posts: n/a
|
Hi,
I now use ICEM to construct structured mesh for CFX-5. For conveniences of block mapping and postprocessing, some inner faces are defined. But when the mesh files were generated for CFX-5, I can't find those inner faces, even they been created as single parts in ICEM. My question is: why outer(as my boundary faces) and inner surfaces/faces are all defined as different parts, why only outer surfaces appear in CFX-Pre£¿ How can I do if I want those inner faces also available in mesh files? |
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ICEM export mesh | Youen | ANSYS Meshing & Geometry | 34 | April 23, 2017 12:15 |
| How to export multizone uns mesh from icem to cgns | july | CFX | 1 | May 1, 2013 09:59 |
| export mesh from ICEM to CFX | alinik | ANSYS Meshing & Geometry | 5 | June 20, 2010 14:38 |
| OpenFOAM on MinGW crosscompiler hosted on Linux | allenzhao | OpenFOAM Installation | 127 | January 30, 2009 19:08 |
| How to Export ICEM mesh to ANSYS Structural | SIVAPRAKAASH | CFX | 4 | December 27, 2007 23:54 |
Linear Mode
