|
[Sponsors] |
August 23, 2004, 10:11 |
Ansys question
|
#1 |
Guest
Posts: n/a
|
Dear Friends, Could someone please help me with the following question about the Ansys software? I am currently modeling a micro part, which is a tube formed by a rolled-up sheet. When I apply a vertical load in the centre of the tube, the resulting deformation is not realistic. The sheet inside goes through the sheet outside. In fact, I think the problem arises earlier after meshing of the part. Since the element size is constant but the radius gets smaller along the rolled-up cross-section, there is some overlap of elements after meshing. Can you please let me know how to solve this problem. Thank you very much
|
|
August 25, 2004, 23:39 |
Re: Ansys question
|
#2 |
Guest
Posts: n/a
|
Wrong forum.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Unanswered question | niklas | OpenFOAM | 2 | July 31, 2013 16:03 |
FSI, Fluent Ansys coupling | Greg Carnie | FLUENT | 5 | January 7, 2010 19:15 |
ANSYS to acquire CFX | Fred | Siemens | 0 | February 18, 2003 21:03 |
problem in reading ansys file | satya bulusu | Siemens | 3 | November 27, 2002 03:29 |
question | K.L.Huang | Siemens | 1 | March 29, 2000 04:57 |