CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   CFX (http://www.cfd-online.com/Forums/cfx/)
-   -   Ansys question (http://www.cfd-online.com/Forums/cfx/20584-ansys-question.html)

Dominik Bell August 23, 2004 10:11

Ansys question
 
Dear Friends, Could someone please help me with the following question about the Ansys software? I am currently modeling a micro part, which is a tube formed by a rolled-up sheet. When I apply a vertical load in the centre of the tube, the resulting deformation is not realistic. The sheet inside goes through the sheet outside. In fact, I think the problem arises earlier after meshing of the part. Since the element size is constant but the radius gets smaller along the rolled-up cross-section, there is some overlap of elements after meshing. Can you please let me know how to solve this problem. Thank you very much

Jeff August 25, 2004 23:39

Re: Ansys question
 
Wrong forum.


All times are GMT -4. The time now is 02:10.