CFX post-processor error!
 

I have the referent problem:

when creating isosurfaces, sometimes the post-processor are closed and the follow message appears:

================================================== ==

CFX-5.7 (C) 1996-2004 CFX Ltd. All rights reserved. signal 11 was caught: segmentation violation Socket::sockWarning!

CFX-POST exited with return code 1

etRecv: Socket error in read: recv: connection reset comm::error: GUIInterface::waitInput - The return code from CUEProtocol is empty . Engine state was dumped to C:/Documents and Settings/newmar/.cfx/cfxpost/dump.cs t Socket::socketRecv: Socket error in read: recv: connection reset ================================================== ==

There is some solution for this problem?

Thanks, Carlos Newmar

Re: CFX post-processor error!
 

Hi Carlos,

You have crashed the post processor. It might be a bug in the software or a problem with your setup. I would report it to your CFX rep.

Glenn Horrocks

Re: CFX post-processor error!
 

I have such experience many times. For all users I have installed Detonator 44.71 (I found this works - we have NVidia graphic boards, but not Quadro). This is graphic drivers problem. I have found that any drivers,that I tested, greater than 50.00 cause such problems.