Error when changing timestep in transient run
Hi, I sometimes got this error massage when I changed the timestep during the run(transient).
---------------- Error detected by routine PEEKCS CDANAM= probe /MONP6/GVAR_WHERE CRESLT=NONE I don't have this problem before. Can anyone tell me what is it? Thank you very much. |
Re: Error when changing timestep in transient run
Hi,
The problem is actually with a monitor point. Glenn Horrocks |
Re: Error when changing timestep in transient run
Yes, I can see that from "probe" in the error massage since I monitored pressure, temperature, density and velocity at three points. But I can't figure out the reason of that error.
Thanks. |
Re: Error when changing timestep in transient run
how?
|
Re: Error when changing timestep in transient run
I have been told that the bug will be fixed with 5.7.1. Similar strange features pop up when the the end time of a transient simulation will be changed on the run.
Astrid |
All times are GMT -4. The time now is 00:09. |