CFX/Gridgen

January 17, 2005, 05:38

Does anyone use Gridgen to generate meshes for later export to CFX5 ? If so can please share your experience with me in terms of compatibility and what to watch for ? Thanks

January 17, 2005, 05:52

Hi,

You should have a look at ICEM or CFX-mesh. Drop me an email and I'll answer your questions!

Cheers Fred

January 17, 2005, 06:59

Thanks Fred, Will keep in touch

January 17, 2005, 16:06

Hi Akin,

A while back I did a trial of Gridgen, ICEM and a number of other meshing packages. This is in the days where the pre-processor included in CFX was CFX-Build. I remember Gridgen being quite a powerful mesher, and able to generate good quality meshes on the complicated geometries I was using. I remember no compatibility issues.

Glenn Horrocks

January 17, 2005, 05:38	CFX/Gridgen	#1
Akin Guest Posts: n/a	Does anyone use Gridgen to generate meshes for later export to CFX5 ? If so can please share your experience with me in terms of compatibility and what to watch for ? Thanks

January 17, 2005, 05:52	Re: CFX/Gridgen	#2
Frederic Guest Posts: n/a	Hi, You should have a look at ICEM or CFX-mesh. Drop me an email and I'll answer your questions! Cheers Fred

January 17, 2005, 06:59	Re: CFX/Gridgen	#3
Akin Guest Posts: n/a	Thanks Fred, Will keep in touch

January 17, 2005, 16:06	Re: CFX/Gridgen	#4
Glenn Horrocks Guest Posts: n/a	Hi Akin, A while back I did a trial of Gridgen, ICEM and a number of other meshing packages. This is in the days where the pre-processor included in CFX was CFX-Build. I remember Gridgen being quite a powerful mesher, and able to generate good quality meshes on the complicated geometries I was using. I remember no compatibility issues. Glenn Horrocks