|April 22, 2005, 04:43||
Wall Heat Transfer Plot
I need to create a contour plot of the "Wall Heat Transfer Co-efficient" (manually calculated as h = q/(Tw-Tref)). The reference temperature is the temperature at a distance away from the wall.
Is there a way of writing a CEL Expression which will evaluate h with the reference temperature taken from the offset location? The "probe" function allows you to use the Temperature from a particular point, but would only give me one value of Tref for the entire surface, so is not suitable.
Any help would be much appreciated
|Thread||Thread Starter||Forum||Replies||Last Post|
|Syntax errors with Thread Types and Wall Heat Transfer calculation||jcespada||Fluent UDF and Scheme Programming||2||March 16, 2012 03:23|
|natural convection||mehrdadeng||CFX||10||February 25, 2011 06:25|
|Heat transfer coefficent for the coupled wall||jing113cn||FLUENT||5||February 24, 2010 04:12|
|Flow around pipes - heat transfer coefficient on the wall of pipe||doodek||Main CFD Forum||2||November 23, 2009 09:48|
|Concentric tube heat exchanger (Air-Water)||Young||CFX||5||October 6, 2008 23:17|