CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   CFX (http://www.cfd-online.com/Forums/cfx/)
-   -   problem in import ANSYS mesh (http://www.cfd-online.com/Forums/cfx/21214-problem-import-ansys-mesh.html)

sheryl April 30, 2005 01:50

problem in import ANSYS mesh
 
I am trying to import an meshed model created in ANSYS to CFX. but after import, it losts its 2D areas and turns out to be a whole block. How can I creat bondary condition with that? The 'HELP' of CFX-pre says: 'to import 2D and 3D region into CFX, each region must be defined with CMBLOCK commands when they are created in ANSYS' But I can not find such a command in ANSYS. I tried CM command to creat areas, but it doesn't work! Does anyone know how to solve this problem? Thank you very much!

luis April 30, 2005 09:17

Re: problem in import ANSYS mesh
 
Use component(CM) one's again, but NODES.

sheryl April 30, 2005 21:30

Re: problem in import ANSYS mesh
 
Hi, it works! Thank you very much!!!
:)


All times are GMT -4. The time now is 16:39.