CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   CFX (http://www.cfd-online.com/Forums/cfx/)
-   -   Problem about contour (http://www.cfd-online.com/Forums/cfx/21386-problem-about-contour.html)

LQ June 28, 2005 22:42

Problem about contour
 
Hi

When I checked the "show numbers" checkbox in the contour card, I found that the number had been showed is 1,2,3,4......

How can I get the factual value of the contour in Post?

All your advice will be very appreciated.

Rui June 29, 2005 07:44

Re: Problem about contour
 
Hi,

I think you can't.But if have checked the "show numbers" box, when you create a Legend, or on the Default Legend, you'll be able to see the contour labels between brackets and their respective values.

Regards,

Rui

LQ July 1, 2005 22:36

Re: Problem about contour
 
Rui

Thank you for your help.

I have another question. In Turbgrid 2.2.1 I cann't use the H grid for the tip of a turbine rotor . Thus I used the "H- no matching "selection. But it seems that this kind of mesh of a tip is difficult to converge.

Could you offer me some idea for dealing this?


Rui July 2, 2005 09:53

Re: Problem about contour
 
Hi,

I'm sorry but I can't help you. I just work with CFX-5, I've never used Turbogrid.

LQ July 2, 2005 21:57

Re: Problem about contour
 
Rui

Thank you all the time.


All times are GMT -4. The time now is 10:02.