CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > CFX

2D in CFX

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Display Modes
Old   July 26, 2005, 20:52
Default 2D in CFX
  #1
Arnaldo
Guest
 
Posts: n/a
Hello All,

I am attempting a 2D model with CFX.

I am aware that CFX does not include a 2D solver but an equivalent solution can be achieved by using an extruded mesh, 1 element wide and imposing symmetry plane on both the "bottom" (initial) face and the "top" face.

I have followed the above but the results are quite a few magnitudes higher than those presented by a 3D simulation. I can only think that perhaps the above approach is not correct, please advise on possible methods.

Kind regards, Arnaldo
  Reply With Quote

Old   July 27, 2005, 18:29
Default Re: 2D in CFX
  #2
Glenn Horrocks
Guest
 
Posts: n/a
Hi,

If you are specifying your inlets as mass flow rate then you may have to scale the flows down to the size of the inlet rectangle or wedge. That is, if you are doing an axisymmetric flow with 1 m^3/s flow rate and you have a 5 degree wedge then your model should be scaled down to have 5/360=0.01389 m^3/s flow rate.

Glenn Horrocks
  Reply With Quote

Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
[ICEM] Proper way to name boundaries on 2D model for use in CFX? RossFS ANSYS Meshing & Geometry 4 November 10, 2011 03:38
Pros and Cons for CFX, CFdesign, COMSOL Val Main CFD Forum 3 June 10, 2011 02:20
CFX pressure in Simulations problem nasdak CFX 1 April 14, 2010 13:22
PhD using CFX Rui CFX 9 May 28, 2007 05:59
CFX 4.4 installation problem Pandu Sattvika CFX 1 December 1, 2001 05:07


All times are GMT -4. The time now is 15:03.