CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   CFX (http://www.cfd-online.com/Forums/cfx/)
-   -   grids between tip clearance (http://www.cfd-online.com/Forums/cfx/21590-grids-between-tip-clearance.html)

iceraining September 6, 2005 09:34

grids between tip clearance
 
hi,everyone.

my model is a axial pump,and the tip clearance is very short to the whole radius. and i met a problem for grids.

when i make ogrids for blade,i don't know where to put the ogrids vertices between the shroud and blade tip. and some grids are always wrong with small angel ,such as 0-9 degree. how to avoid this situation?

thank you very much!


karunakara September 7, 2005 05:19

Re: grids between tip clearance
 
I dint get your question saying the axial pump having a shroud? In axial flow pumps the impeller blades are with the hub only. What is the clearence between impeller and casing.?


iceraining September 7, 2005 08:11

Re: grids between tip clearance
 
ah~ the pump was cased, and tip clearance is very small.could you tell me how to set the grids? thank you very much!


All times are GMT -4. The time now is 02:19.