CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   CFX (http://www.cfd-online.com/Forums/cfx/)
-   -   Why there is a hole in my structure by using ICEM (http://www.cfd-online.com/Forums/cfx/21632-why-there-hole-my-structure-using-icem.html)

Ho September 21, 2005 05:31

Why there is a hole in my structure by using ICEM
 
Hallo,

Need everyone's help. I would like to draw a Laval nozzle (2D)using ICED CFD. I use the commands "point", "Curve" to construct it, but when doing the meshing, the message " there is a hole in the structure" appeared. Why? Thank you

Myron September 21, 2005 09:45

Re: Why there is a hole in my structure by using I
 
You probably need to create the 2D surface as well.

Begonia September 22, 2005 10:05

Re: Why there is a hole in my structure by using I
 
Try to setup the global element scale factor/seed size .. properly , and it will be OK.


All times are GMT -4. The time now is 13:05.