 |
 |
 |
|
|
|
[Sponsors] | ||||
October 6, 2005, 18:43
|
Unable to block
|
#1 |
|
Guest
Posts: n/a
|
I am trying to use the surface meshing mapped based method using the quad dominate scheme. I have a couple surfaces that are not able to block. I don't see why they cannot. Does any one know why this happens? I have tried changing the element size and everytime I choose that surface to mesh it tells me unable to block surface. Any help will be appreciated.
|
|
|
||
|
October 6, 2005, 18:44
|
Re: Unable to block
|
#2 |
|
Guest
Posts: n/a
|
This is using ICEM CFD 5.1
|
|
|
|
||
|
October 7, 2005, 09:12
|
Re: Unable to block
|
#3 |
|
Guest
Posts: n/a
|
Probably best to contact your technical support provider - and provide the model to them.
|
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] Quest for seemingly simple Blocking (degenerate block) | la7low | ANSYS Meshing & Geometry | 0 | July 12, 2011 19:48 |
| [ICEM] Hexa to Sweep block conversion | pertupd | ANSYS Meshing & Geometry | 1 | June 19, 2010 21:37 |
| [Commercial meshers] Icem Mesh to Foam | jphandrigan | OpenFOAM Meshing & Mesh Conversion | 4 | March 9, 2010 02:58 |
| blockMesh: block with 6 vertexes | dani | OpenFOAM | 3 | June 25, 2009 13:13 |
| [Commercial meshers] ST_Malloc: out of memory.malloc_storage: unable to malloc Velocity SA, | cfdproject | OpenFOAM Meshing & Mesh Conversion | 0 | April 14, 2009 15:45 |
Linear Mode
