Transient simulation error on start -
- How to diagnose?
I have the following strings in output file for transient simulation. The initial conditions was taken from the same steady state simulation. ========= +--------------------------------------------------------------------+ | Average Scale Information | +--------------------------------------------------------------------+ Domain Name : WaterAll Global Length = 2.9068E-01 Minimum Extent = 8.0000E-03 Maximum Extent = 1.8130E+00 Density = 9.9700E+02 Dynamic Viscosity = 8.8990E-04 Velocity = 2.8490E-01 Advection Time = 1.0203E+00 RMS Courant Number = 1.0411E+02 Maximum Courant Number = 1.1047E+03 Reynolds Number = 9.2780E+04 **** Error in subroutine GETDAT ***** Name of data area requested = RESF/OUTPUT_RESEQN Size of data area requested = 20 Size of data area obtained = 3 +--------------------------------------------------------------------+ | Writing crash recovery file | +--------------------------------------------------------------------+ +--------------------------------------------------------------------+ | ERROR #001100279 has occurred in subroutine ErrAction. | | Message: | | Stopped in routine GETDAT | | |
Re: Transient simulation error on start -
Dear Korsh,
I would contact your CFX help desk. I have seen the same message and it is supposed to be fixed in the next service pack coming out sometime this month.. Good luck, Opaque |
All times are GMT -4. The time now is 13:43. |