Low Inlet Turb. Intensity - SST model not converge -- CFD Online Discussion Forums

November 12, 2005, 01:26	Low Inlet Turb. Intensity - SST model not converge	#1
Pete Guest Posts: n/a	Hi, I'm simulating flow in a diffusing bend. The inlet turbulent intensity that I measured from exp is only 0.5%. However, I found it very difficult to converge using such a low TI in SST model (residuals flat at 10^-3 for 1000 steps). I have to set TI as high as 3% to get the solution to converge to 10E-6. Anyone know how to modify the parameters in SST model to improve the convergence? Thanks,Pete

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Water subcooled boiling	Attesz	CFX	7	January 5, 2013 03:32
Understanding k-omega SST model source code	tmhonka	OpenFOAM Programming & Development	1	September 8, 2009 07:33
How to model Low Reynolds Turbulent in SST K-omega	asghari	FLUENT	0	August 18, 2007 03:31
jet oscillation at low inlet Re	wood	Main CFD Forum	1	October 21, 1999 13:45
a low Re number model for impinging jets	mahesh prakash	Main CFD Forum	14	September 3, 1999 16:40

All times are GMT -4. The time now is 03:03.