|
[Sponsors] |
December 1, 2005, 14:59 |
Error message from the CFX5 Post
|
#1 |
Guest
Posts: n/a
|
I use Sun Blade and have an error message while I am using Post to create a velocity contour plot on the symmetry plane.
The message I have from the computer is /././cfx-5.7/bin/splaris/PostGui_ogl was interruped by signal BUS (10) and dumped core. Comm::error:GUIInterface::waitInput - The return code from CUEProtocol is empty. Engine state was dumped to .... Is there anyone to give me any suggestions? Thanks. |
|
December 6, 2005, 14:03 |
Re: Error message from the CFX5 Post
|
#2 |
Guest
Posts: n/a
|
This means the program crahsed, probably caused by the graphics card. If you run in software graphics rendering mode it will most likely work fine, but the graphics will be slower:
cfx5post -gr mesa You could check for updated drivers for you graphics card too. Mike |
|
December 9, 2005, 17:08 |
Re: Error message from the CFX5 Post
|
#3 |
Guest
Posts: n/a
|
Thank, Mike. I will try it.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
NO model vs post processing in coal combustion,CFX | sakalido | CFX | 1 | April 15, 2011 14:07 |
post processing for KIVA | dirga | Main CFD Forum | 5 | April 23, 2009 10:58 |
Linking between my own code and CFX5 in Windows | Se-Hee | CFX | 2 | May 17, 2007 08:52 |
Post Processing in FEM | Abhijit Tilak | Main CFD Forum | 0 | April 26, 2004 11:59 |
mpeg in CFX5 POST | henry | CFX | 7 | November 23, 2002 15:50 |