CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   CFX (http://www.cfd-online.com/Forums/cfx/)
-   -   Doubt Regarding macro calculator option in CFX (http://www.cfd-online.com/Forums/cfx/21963-doubt-regarding-macro-calculator-option-cfx.html)

Sridevi December 21, 2005 04:55

Doubt Regarding macro calculator option in CFX
 
Dear all,

I m doing simulation on Axial blower and during post processing I would like to view the Perfomance macro of blower with the option of gas compressor .

I m getting error as "total temperature in stn frame is not existing " .where as my simulation is steady and does not involve any temperature data.I m also not getting the view report tab highlighted in the bottom of the option.I have taken air at 25 degree centigrade as the fluid which is in CFX material library.And the rotating domain's angular velocity is 4800 RPM with outlet mass flow rate of 10000 CFM. I m also using hexa mesh for the simulation.

Can anybody help on this issue so that it will be easy to sort out my problem. ? Thanks in advance !!! Sridevi



All times are GMT -4. The time now is 00:22.