About defination of mesh region

January 15, 2006, 20:55

Good everyone

I have some troubles with the defination of mesh region. How can I divide the smaller mesh regions from a big region except the CCL method. For example, I want to divide the Outlet region from a big regions in CFX-Pre. HOw can I do it? Thank your help.

January 16, 2006, 04:42

If you haven't started your meshing, I'll suggest dividing this big region into smaller parts, mesh them separately and then use interface to join them up in Pre.

January 16, 2006, 18:45

Thank you

January 15, 2006, 20:55	About defination of mesh region	#1
koukouken Guest Posts: n/a	Good everyone I have some troubles with the defination of mesh region. How can I divide the smaller mesh regions from a big region except the CCL method. For example, I want to divide the Outlet region from a big regions in CFX-Pre. HOw can I do it? Thank your help.

January 16, 2006, 04:42	Re: About defination of mesh region	#2
TB Guest Posts: n/a	If you haven't started your meshing, I'll suggest dividing this big region into smaller parts, mesh them separately and then use interface to join them up in Pre.

January 16, 2006, 18:45	Re: About defination of mesh region	#3
koukouken Guest Posts: n/a	Thank you

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Generating Mesh for STL Car in Windtunnel Simulation	tommymoose	ANSYS Meshing & Geometry	48	April 15, 2013 04:24
problem with Min/max rho	tH3f0rC3	OpenFOAM	7	February 23, 2013 05:37
[ICEM] Airfoils meshing, how create a more dense mesh region?	Bigio	ANSYS Meshing & Geometry	6	March 16, 2012 14:02
Cht tutorial in 15	braennstroem	OpenFOAM Running, Solving & CFD	195	February 6, 2012 10:49
Problem in defining porous region on an imported tetrahedral mesh	run_cfd	OpenFOAM Pre-Processing	0	May 24, 2011 02:15