 |
 |
 |
|
|
|
[Sponsors] | ||||
September 7, 2019, 03:16
|
Mass flow rate setting in CFX-pre
|
#1 |
|
Member
Nate Lau
Join Date: Mar 2016
Posts: 33
Rep Power: 10  |
Dear everyone, in one-passage simulation (one blade) for an axial fan, when I set the value of mass flow rate at the inlet, does I assign the mass flow rate for the whole fan or only the single passage?
|
|
|
|
|
|
September 8, 2019, 14:48
|
|
#2 |
|
Senior Member
Gert-Jan
Join Date: Oct 2012
Location: Europe
Posts: 1,827
Rep Power: 27 |
I would say: "Give it a try".
|
|
|
|
|
|
|
September 8, 2019, 19:05
|
|
#3 |
|
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,703
Rep Power: 143 |
That's right. This is why I did not answer this question. Just do a model and look at the results and work it out for yourself. I am not going to answer a question which will only require a few minutes of investigation to answer.
__________________
Note: I do not answer CFD questions by PM. CFD questions should be posted on the forum. |
|
|
|
|
 |
| Tags |
| cfx cfx-pre |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Specify mass flow rate for periodic boundary conditions in channel flow | lion1990 | OpenFOAM Running, Solving & CFD | 1 | July 9, 2018 17:46 |
| Target Mass Flow Rate | Nitin | FLUENT | 9 | June 17, 2017 10:30 |
| Uniform mass flow rate at different outlets. | mehcaecfd | STAR-CCM+ | 6 | May 18, 2016 02:34 |
| particle, parcel and mass flow rate balance | flybird | FLUENT | 0 | May 24, 2007 10:44 |
| How to change from mass flow to volume flow rate | stanley | FLUENT | 1 | February 2, 2007 06:44 |
5Likes
Linear Mode
