|
[Sponsors] |
May 13, 2006, 13:34 |
translational periodicity
|
#1 |
Guest
Posts: n/a
|
Hi everyone.I defined translational periodicity by setting offset ,( 200 0 0 ) in set global mesh size for the periodic faces apart 200mm. but at the time of mesh check for periodicity it gives amessage ' there is no periodicity defined in the mesh',please suggest me how to define periodicity thank u
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
periodic boundary condition (translational) fluent 6.3 | haihek | FLUENT | 3 | January 22, 2014 04:10 |
Periodicity lost during quater ogrid blocking | syler3321 | ANSYS Meshing & Geometry | 0 | October 17, 2011 23:24 |
Translational Periodicity / Velocity Profile | sberez | CFX | 1 | November 15, 2009 17:29 |
Periodicity in CFX | Sam S | CFX | 2 | August 27, 2007 00:59 |
Ensight 8.0 translational periodicity | Francesco | EnSight | 0 | May 16, 2006 19:40 |