CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > CFX

About a simulation,help.

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Display Modes
Old   May 19, 2006, 02:31
Default About a simulation,help.
  #1
jasonchang
Guest
 
Posts: n/a
Hi,all:

I want to simulate such model:let water of 100 [c] fill into a converted container with the inlet underside.The container is in vacuum,the pressure is 1000[Pa].

There is no outlet boundry condition here.

How should implement this simulation? Any reply will be appreciated.

Best wishes.

jason
  Reply With Quote

Old   May 23, 2006, 23:58
Default Re: About a simulation,help.
  #2
Vijesh Joshi
Guest
 
Posts: n/a
Hi, Cannot understand the problem properly, Please elaborate a little on vacuum and pressure conditions. I am interested in your problem. Regards, VVJ.
  Reply With Quote

Old   May 25, 2006, 04:34
Default Re: About a simulation,help.
  #3
jasonchang
Guest
 
Posts: n/a
Dear Vijesh :

I am simulating a foundry model. At first, As supposed, I use water as the liquid to fill the vessel. Indeed the vessel is made of sand and clay.The melting aluminium fill into it and concrete ,forming a casting . The vessel has an inlet underside,and the wall that made of sand just allowing the air flowing out. So the water can only flow into the vessel.

Maybe I need to use the multiphase model and free surface model to simulate it.Expecting for your suggestion.

The pressure of inlet is 4 atm,with the velocity of 0. and the pressure in the vessel is 1000Pa.

Thank you in advance

  Reply With Quote

Old   May 26, 2006, 05:19
Default Re: About a simulation,help.
  #4
Vijesh Joshi
Guest
 
Posts: n/a
Hi, I have a an idea to solve this problem (the results may not be so accurate). 1.Apply inlet conditions on the inlet surface. 2. Apply WALL conditions to the bottom surface of the vessel. 3. Apply OPENING conditions on the perpheral surface of the vessel and say the pressure to be 1000Pa IN THE DIRECTION OF COMPRESSING THE VESSEL. Because, inside the vessel the pressure is 1000Pa. The vessel to be in equilibrium, the sand surafce must exert the equal pressure in the opposite direction. Try this. Regards, VVJ
  Reply With Quote

Old   May 26, 2006, 08:52
Default Re: About a simulation,help.
  #5
jasonchang
Guest
 
Posts: n/a
Hi,VVJ

Glad to see you again. If set the Apply OPENING conditions on the perpheral surface of the vessel ,gas can flow through the boundary,at the same time, water,or aluminium fluid I will use at last,can also flow through it ,too.It's not what I wanted.

set the pressure to be 1000Pa IN THE DIRECTION OF COMPRESSING THE VESSEL,How to set it,can you write in details?

Regards, Jason
  Reply With Quote

Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
large eddy simulation,help!!! Danney Main CFD Forum 1 December 24, 2002 02:52


All times are GMT -4. The time now is 14:09.