 |
 |
 |
|
|
|
[Sponsors] | ||||
June 9, 2006, 21:54
|
turbine compt:why can't congence???
|
#1 |
|
Guest
Posts: n/a
|
i did some turbine computation! i chose air(idea gas) as fluid, and reference pressure=14atm;energy model----total energy;k-e model;intial condition=automatic
BC:inlet---mass rate;total tempreture=1200K; outlet----reletive pressure=-600000Pa; it never congence,but when i turn outlet's reletive pressure to 0Pa,it congence,it that 14atm have some problem?if not,where can i modify them? how this could happen,and what can i do? thanks in advance!!! |
|
|
||
|
June 12, 2006, 02:09
|
Re: turbine compt:why can't congence???
|
#2 |
|
Guest
Posts: n/a
|
anyone can help me with this problem?
plz!!! |
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem with torque output from a turbine simulation. | pa-dundas | FLUENT | 5 | July 17, 2022 05:27 |
| Water turbine CFD modeling | Peter | Main CFD Forum | 7 | April 4, 2016 02:31 |
| FSI - Wind Turbine | AUN | CFX | 13 | August 29, 2012 16:44 |
| HAWT, should we use sliding meshes? or the UDF? | f0208secretx | FLUENT | 11 | February 19, 2012 05:58 |
| turbine noise | naser | FLUENT | 0 | December 3, 2004 13:37 |
Linear Mode
