|
[Sponsors] |
September 4, 2006, 09:18 |
Solver stoped without creating a result file
|
#1 |
Guest
Posts: n/a
|
Hi, My Problem is: I have a transient simulation and I wanted to simulate 180 seconds. But after ca. 100 sec the solver stoped without creating a result file. But I have a lot of transient files written in a directory. My question is now, how can i get or is it possible to get the information of these transient files?
Thank you Roland |
|
September 4, 2006, 13:09 |
Re: Solver stoped without creating a result file
|
#2 |
Guest
Posts: n/a
|
I doubt it, they wont have the required geometry information.
To avoid this happening in future, use output control to write a full backup every x number of timesteps. Then you can access all the transient files preceeding the last full backup. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2.0.x on Mac OSX | niklas | OpenFOAM Installation | 74 | March 28, 2012 16:46 |
ParaView Compilation | jakaranda | OpenFOAM Installation | 3 | October 27, 2008 11:46 |
Regarding FoamX running Kindly help out | hariya03 | OpenFOAM Pre-Processing | 0 | April 18, 2008 04:26 |
gcc and executable file from Mac to Linux | simone Marras | Main CFD Forum | 0 | April 8, 2007 15:49 |
[blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |