CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > CFX

ICEM problem

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Display Modes
Old   October 27, 2006, 08:54
Default ICEM problem
  #1
Ali
Guest
 
Posts: n/a
Hi all,

I'm simulating a wind tunnel test for a flow over hydrofoil. After making the mesh, I see mesh elements penetrate the foil with a small hole in the mesh around the foil end. Where is the problem? The foil has a top, bottom and side surfaces. Why the mesh inside the foil not around?

Any guides are welcome.

Ali

  Reply With Quote

Old   October 27, 2006, 10:03
Default Re: ICEM problem
  #2
Robin
Guest
 
Posts: n/a
If the top and bottom surfaces are very close, the projection algorithm in tetra may get them mixed up. To prevent this, define the top and bottom surfaces as a "thin cut". See the documentation for how to do this.

-Robin
  Reply With Quote

Old   October 27, 2006, 10:31
Default Thanks Robin
  #3
Ali
Guest
 
Posts: n/a
Thanks Robin That's very helpful and fast.

Ali
  Reply With Quote

Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
ICEM - strange linking problem RodriguezFatz ANSYS Meshing & Geometry 3 October 25, 2011 03:25
[ANSYS Meshing] Problem with Icem Script Krish ANSYS Meshing & Geometry 0 October 18, 2011 12:10
[ICEM] Problem while improting Solidworks Part file or Acis File into ICEM CFD venki1130 ANSYS Meshing & Geometry 0 October 13, 2011 13:04
ICEM boundary condition problem Martin_D ANSYS Meshing & Geometry 2 February 14, 2011 11:20
Icem to FLUENT problem Babak FLUENT 0 June 10, 2010 17:14


All times are GMT -4. The time now is 08:10.