 |
 |
 |
|
|
|
[Sponsors] | ||||
November 29, 2006, 03:23
|
2-D mesh in ansys
|
#1 |
|
Guest
Posts: n/a
|
is it possible to build a 2-D mesh in ansys like fluent. if it please explain how? thanq
|
|
|
||
|
November 29, 2006, 05:20
|
Re: 2-D mesh in ansys
|
#2 |
|
Guest
Posts: n/a
|
No, it is not possible. CFX only handles 3D meshes. If you like to do a 2D simulation, you have give your mesh a thickness of 1 element. Then you can set the boundary conditions at both planes to symmetry.
Regards Patrick |
|
|
|
||
|
December 4, 2006, 13:26
|
Re: 2-D mesh in ansys
|
#3 |
|
Guest
Posts: n/a
|
1.Make 2D geometry and Mesh it. 2.Extrude it by one element. 3.Define as symmetry on both side.
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] SnappyHexMesh for internal Flow | vishwa | OpenFOAM Meshing & Mesh Conversion | 24 | June 27, 2016 08:54 |
| Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 06:20 |
| [ICEM] Unstructure Meshing Around Imported Plot3D Structured Mesh ICEM | kawamatt2 | ANSYS Meshing & Geometry | 17 | December 20, 2011 11:45 |
| Convergence moving mesh | lr103476 | OpenFOAM Running, Solving & CFD | 30 | November 19, 2007 14:09 |
| Problem importing GAMBIT mesh to Ansys geometry | David G. | CFX | 0 | June 19, 2005 06:01 |
Linear Mode
