wall boundary
hello everybody,
i am modeling liquid solid flows in riser,i want to specify the wall boundary as a partial slip for solid phase and no slip for liquid phase. is there any way to specify the partial slip bounday condition in CFX 10.0 thanks bye CFDUSER |
Re: wall boundary
Dear CFDUSER,
1 - Go to CFX-Pre, open wall boundary panel 2 - On the boundary details tab, under Wall Influence on the Flow select Fluid Dependent.. 3 - On the Fluid Values tab, fill in the Free Slip and No Slip conditions for each fluid under Wall Influence on the Flow Opaque |
Re: wall boundary
Dear opaque
thanks for your comments, i am asking setup of user defined partial slip boundary for solid phase with regards CFDUSER |
All times are GMT -4. The time now is 02:16. |