Thin Surface not taken
Hello! I am simulating a combustion chamber and the guide vanes in the inlet are set as a wall. When I simulate it, the flow doesn't take this condition and the flow goes through this surfaces. I have tried several ways, but it says in the out file that the boundary condition is a wall in the vanes, but the stream lines and everything are not consistent with this..
Does somebody have had this problem? What could be causing this? I have tried with the option of thin surface and with out this option and i get the same problem. Any sugestion would be very appreciated! Thanks! Maria Angelica |
All times are GMT -4. The time now is 15:23. |