Thin Surface not taken -- CFD Online Discussion Forums

December 8, 2006, 20:38	Thin Surface not taken	#1
Maria Angelica Guest Posts: n/a	Hello! I am simulating a combustion chamber and the guide vanes in the inlet are set as a wall. When I simulate it, the flow doesn't take this condition and the flow goes through this surfaces. I have tried several ways, but it says in the out file that the boundary condition is a wall in the vanes, but the stream lines and everything are not consistent with this.. Does somebody have had this problem? What could be causing this? I have tried with the option of thin surface and with out this option and i get the same problem. Any sugestion would be very appreciated! Thanks! Maria Angelica

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Problems with coedge curves and surfaces	tommymoose	ANSYS Meshing & Geometry	6	December 1, 2020 11:12
[Gmsh] Error : Self intersecting surface mesh, computing intersections & Error : Impossible	velan	OpenFOAM Meshing & Mesh Conversion	3	October 22, 2015 11:05
[Gmsh] Problem with Gmsh	nishant_hull	OpenFOAM Meshing & Mesh Conversion	23	August 5, 2015 02:09
CFX4.3 -build analysis form	Chie Min	CFX	5	July 12, 2001 23:19
free convection heat transfer from a heated horizontal surface through a liquid to a thin cooled fin	Kaushik	FLUENT	1	May 8, 2000 06:47

All times are GMT -4. The time now is 14:16.