|
[Sponsors] |
January 16, 2007, 09:10 |
Mismatch node
|
#1 |
Guest
Posts: n/a
|
why there always mismatch at periodic node after i generate the surface mesh?why its difficult to generate mesh at small internal angle?
Thank You. |
|
January 16, 2007, 09:12 |
Re: Mismatch node
|
#2 |
Guest
Posts: n/a
|
In icem CFD you must specify the surface pairs are periodic to avoid this.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Export node number and coordinates | kezman | CFX | 2 | November 7, 2015 15:45 |
Accessing node values using a UDF | Nico | FLUENT | 2 | December 20, 2007 02:50 |
License server not visible from master node | Charles | FLUENT | 0 | October 30, 2007 17:48 |
how can i list node temperatur by node location | Ali Doustdar | FLUENT | 2 | July 12, 2007 23:48 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |