How make a .gtm grid for pre-CFX using ICEM ?????

January 24, 2007, 05:04

Dear all,

I've a problem....

How export or create a valid .gtm mesh file for pre-CFX 10.0 using ICEM 10.0?

Thanks All.

Igna

January 24, 2007, 07:17

Hi Igna,

What I do is to write the output file from ICEM in "ANSYS CFX" format (not only "ANSYS"), which creates a *.cfx5 file. Then I import the *.cfx5 into CFX-Pre under Mesh / Import Mesh / Mesh Format "ICEM CFD".

Hope it helps.

flga

January 24, 2007, 08:36

I think maybe you can get *.msh file in ICEM 10.0. Then in CFX-pre, you can seclect ICEM mesh(that *.msh file). Good luck.

January 24, 2007, 05:04	How make a .gtm grid for pre-CFX using ICEM ?????	#1
IGNA Guest Posts: n/a	Dear all, I've a problem.... How export or create a valid .gtm mesh file for pre-CFX 10.0 using ICEM 10.0? Thanks All. Igna

January 24, 2007, 07:17	Re: How make a .gtm grid for pre-CFX using ICEM ??	#2
flga Guest Posts: n/a	Hi Igna, What I do is to write the output file from ICEM in "ANSYS CFX" format (not only "ANSYS"), which creates a .cfx5 file. Then I import the .cfx5 into CFX-Pre under Mesh / Import Mesh / Mesh Format "ICEM CFD". Hope it helps. flga

January 24, 2007, 08:36	Re: How make a .gtm grid for pre-CFX using ICEM ??	#3
Eric Guest Posts: n/a	I think maybe you can get .msh file in ICEM 10.0. Then in CFX-pre, you can seclect ICEM mesh(that .msh file). Good luck.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Can it make extruded 2D meshes for 2D CFX simulations?	siw	ANSYS Meshing & Geometry	10	October 23, 2009 08:47
Installation OF1.5-dev	ttdtud	OpenFOAM Installation	46	May 5, 2009 02:32
Regarding FoamX running Kindly help out	hariya03	OpenFOAM Pre-Processing	0	April 18, 2008 04:26
Tranfer geometry from ICEM to CFX mesh	Adam	CFX	5	November 13, 2006 04:40
price of fluent, cfx, grid gen and icem	confused cfd guru (to be)	Main CFD Forum	0	October 4, 2005 16:47