 |
 |
 |
|
|
|
[Sponsors] | ||||
January 29, 2007, 17:09
|
regular cfx-mesh
|
#1 |
|
Guest
Posts: n/a
|
Hi, I've been trying to create a mesh for a rectangular duct using cfx-mesh. I want the mesh to be made up of rectangular elements (if i was using ansys to create the mesh I'd use the hexagonal and mapping options), does anyone know how to do this using cfx-mesh? Thanks in advance, Kieran
|
|
|
||
|
January 29, 2007, 21:04
|
Re: regular cfx-mesh
|
#2 |
|
Guest
Posts: n/a
|
CFX Mesh only makes tetra/prism meshes. It is possible to get some hex elements by doing a 2D extrusion of an inflation layer, but it is not possible to have a fully structured, mapped hex mesh. You need to use ICEM Hexa for that.
|
|
|
|
||
|
January 30, 2007, 06:51
|
Re: regular cfx-mesh
|
#3 |
|
Guest
Posts: n/a
|
CFX 11 can! See plot.
|
|
|
|
||
|
February 1, 2007, 10:19
|
Re: regular cfx-mesh
|
#4 |
|
Guest
Posts: n/a
|
i want to know how to do a mesh on a vehicle surface
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] SnappyHexMesh for internal Flow | vishwa | OpenFOAM Meshing & Mesh Conversion | 24 | June 27, 2016 08:54 |
| [ICEM] Generating Mesh for STL Car in Windtunnel Simulation | tommymoose | ANSYS Meshing & Geometry | 48 | April 15, 2013 04:24 |
| CFX Mesh Deformation problem | Silmaril | CFX | 7 | October 19, 2010 10:00 |
| Mesh from ICEM CFD to CFX ! Error ! Why ? Thanks ! | Vu Trinh Tuan | CFX | 11 | March 28, 2005 19:04 |
| importing mesh from ICEM CFD into CFX 5 | Jay | CFX | 2 | November 12, 2002 13:46 |
Linear Mode
