|
[Sponsors] |
February 5, 2007, 21:21 |
boudary layer distance in CFX POST
|
#1 |
Guest
Posts: n/a
|
Hello I'm vac. I am modeling a simple duct flow problem and using SST model. Y+ value is below 1.0 and maybe node number in boudary layer is enough, but I want to decrease the node number. How can I know the boudary distance from wall in CFX POST? Thank you in advance.
|
|
February 6, 2007, 05:54 |
Re: boudary layer distance in CFX POST
|
#2 |
Guest
Posts: n/a
|
You need to go back to your mesher and remesh.
|
|
February 15, 2007, 08:34 |
Re: boudary layer distance in CFX POST
|
#3 |
Guest
Posts: n/a
|
You can plot the YPLUS variable in CFX-POST on the wall. This should give you a good idea of the first cell distance from the wall.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
general question about wall distance in ICEM + CFX | Andy | CFX | 6 | February 28, 2013 01:44 |
Transient animation performance in CFX 5.5 POST | Sjoerd Romkes | CFX | 8 | February 5, 2013 14:53 |
chart for transiente simulation - CFX Post | rogbrito | CFX | 0 | June 22, 2009 12:12 |
Assign new variable in CFX Post | Ben | CFX | 1 | August 25, 2008 14:59 |
Proper output of angle of attack in CFX post | Kevin | CFX | 3 | October 18, 2006 12:18 |