|
[Sponsors] |
February 14, 2007, 01:16 |
Modelling of diaphragm for moving mesh
|
#1 |
Guest
Posts: n/a
|
Hi Friends
Can any one tell me how to model diaphragm for moving mesh |
|
February 14, 2007, 21:31 |
Re: Modelling of diaphragm for moving mesh
|
#2 |
Guest
Posts: n/a
|
Hi,
Doing some tutorials sounds like a good start. Glenn Horrocks |
|
February 14, 2007, 22:55 |
Re: Modelling of diaphragm for moving mesh
|
#3 |
Guest
Posts: n/a
|
Hi
I found a tutorial with moving mesh on a ball. But in diaphragm the sides are only fixed and the middle position is subject to movement. one side of the diaphragm is exposed to atmospheric pressure and other to a vacuum. |
|
February 15, 2007, 16:28 |
Re: Modelling of diaphragm for moving mesh
|
#4 |
Guest
Posts: n/a
|
Hi,
This is starting to sound like a FSI simulation. Version 11 (which was released a few days ago) has extensive enhancements in FSI and a few tutorials. I recommend you try it in Version 11. Glenn Horrocks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] Number of cells in mesh don't match with size of cellLevel | colinB | OpenFOAM Meshing & Mesh Conversion | 14 | December 12, 2018 08:07 |
Converting Starccm+ mesh | Ladnam | OpenFOAM | 0 | September 14, 2011 06:30 |
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 21:11 |
Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 18:10 |
2D Modelling using unstructured mesh | Yingchun | CFX | 8 | December 12, 2005 06:05 |