|
[Sponsors] |
March 2, 2007, 21:28 |
export particle traking file
|
#1 |
Guest
Posts: n/a
|
In spray drying process, with CFX 10. When I exported some values from CFX post, I got the following results
0- particle diameter size 8.72E+18 1. particle speed 4.93E+22 m (the injection diameter was 200 micro meter) 2. Particle temperature is 1.11E+29 K 3. particle H2o mass fraction is 1.43E+23 (it should be max 1) However 4. paricle total mass 3.08E-11 kg anyone can explain to me what is the problem with CFX program please please please help me |
|
March 3, 2007, 06:12 |
Re: export particle traking file
|
#2 |
Guest
Posts: n/a
|
Are the values correct in Post, but the problem is when you export the results? Or are the values wrong in Post?
|
|
March 3, 2007, 07:53 |
Re: export particle traking file
|
#3 |
Guest
Posts: n/a
|
The values are wrong in the CFX post
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
wmake compiling new solver | mksca | OpenFOAM Programming & Development | 14 | June 22, 2018 07:29 |
[swak4Foam] swak4foam building problem | GGerber | OpenFOAM Community Contributions | 54 | April 24, 2015 17:02 |
channelFoam for a 3D pipe | AlmostSurelyRob | OpenFOAM | 3 | June 24, 2011 14:06 |
[blockMesh] BlockMesh FOAM warning | gaottino | OpenFOAM Meshing & Mesh Conversion | 7 | July 19, 2010 15:11 |
OF 1.6 | Ubuntu 9.10 (64bit) | GLIBCXX_3.4.11 not found | piprus | OpenFOAM Installation | 22 | February 25, 2010 14:43 |