|
[Sponsors] |
March 25, 2007, 05:18 |
Def file
|
#1 |
Guest
Posts: n/a
|
In CFX10, my work is to study the effect of spray parameters on drying process. Therefore, I made some change in CFx pre and re-run again for each parameters I need to study (I did not delete the Def file, I ask the program to over write). I noted that my Def file increases from run to anther run (become about 1.5 Gb). To my surprised, when I deleted the Def file (CfX will create a new one not overwrite) its size become about 9 MB only.
The question is that is I have ti delete it when I made any change in CFX pre and re- run or not? why its size increases? Is that has any effect on my results (CFX results)? if yes then I have to repeat all of my preivous results Regards Thank you for your help |
|
April 5, 2007, 09:17 |
Re: Def file
|
#2 |
Guest
Posts: n/a
|
Install Service Pack 1 to fix this. It was a bug, but other than the file size it didn't cause any problems (i.e. your results are OK)
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
OpenFOAM 1.7.1 installation problem on OpenSUSE 11.3 | flakid | OpenFOAM Installation | 16 | December 28, 2010 08:48 |
Version 15 on Mac OS X | gschaider | OpenFOAM Installation | 113 | December 2, 2009 10:23 |
OpenFOAM Install Script | ljsh | OpenFOAM Installation | 82 | October 12, 2009 11:47 |
[OpenFOAM] Paraview command not found | hardy | ParaView | 7 | September 18, 2008 04:59 |
DxFoam reader update | hjasak | OpenFOAM Post-Processing | 69 | April 24, 2008 01:24 |